Omnitron Systems Technology MAH 200 ユーザーズマニュアル

CODE READER MAH 200

To connect the MAH 200 to your host computer via RS-232 interface:

1. Make sure the RS-232 cable is sufficiently attached to your MAH 200 unit (figure 2.4).

2. Connect the RS-232 interface cable to your host computer (figure 2.5). If you are unsure of the

proper location to connect the RS-232 cable please consult the manual of your host computer.

3. The RS-232 interface should have come with a power supply. Plug the power supply adapter

into the RS-232 interface cable (figure 2.6) and then plug the power adapter into a wall socket
(figure 2.7).The RS-232 interface does not require additional power. However, if you are using
the RS-232 interface and utilizing Batch functionality, please read the Important Note in section
7.1. If you are using the 1300 mA or 1800 mA battery for batch mode, the MAH 200 will
recharge the battery whenever the unit is a attached to a RS-232 cable that is plugged into a wall
socket.

4. The MAH 200 will power on automatically.

5. Scan the RS-232 One Way Mode code then the Save Settings code to configure reader:

6. Your MAH 200 unit should be ready for use. Open the application (any Serial
Communications Software – e.g. Hyper Terminal) you wish to send data and begin scanning.

Baud Rate

57600

Stop Bits

1

Data Bits

8

Parity

None