Q-Logic Computer Drive 8200 SERIES ユーザーズマニュアル
3 – Getting Started with SANbox SSP
Setting Up SANbox SSP
3-6
SN0054628-00 A
Q
3. Lock the supply in place by rotating the knob clockwise until it stops.
4. Once the power supply has been properly inserted, connect a power cable from
an electrical outlet to the power connector on the port side.
The corresponding power supply LED should be illuminated indicating that the
power supply and power cable have been properly installed.
power supply and power cable have been properly installed.
5. Repeat
through
for the second power supply, inserting the power
supply into the power supply slot on the far right.
Figure 3-4. Inserting the Right Power Supply
6. Plug in both power cables.
NOTE:
Note: For maximum fault tolerance, plug the power cables into
separate circuits.
separate circuits.
To connect the console port:
Attach the provided serial cable between the serial (console) port (labeled
) on
SANbox SSP and an RS-232 serial port on your laptop or host computer.
If the serial cable provided with SANbox SSP is not available, use a standard RS-232
null-modem cable to connect the console port to a host computer.
null-modem cable to connect the console port to a host computer.
to see exactly where the console port is located.