Q-Logic Computer Drive 8200 SERIES ユーザーズマニュアル

3 – Getting Started with SANbox SSP

 

Setting Up SANbox SSP

3-8

SN0054628-00  A

Q

1. Type modify eth to configure the IP address for the management port (labeled 

 on the port side of SANbox SSP), and enter your IP address, subnet mask, 

and gateway parameters. 

Use the management port, labeled 

,to connect your SANbox SSP 

to your LAN for management access. If you are connecting SANbox 
SSP to a host computer instead of an Ethernet network, you must 
use a crossover Ethernet cable.

You can connect your host computer directly to the management port 
using a crossover cable. If you want to do so without first configuring 
the management Ethernet port via the serial console, the default 
parameters for the port are:

 

 
IP address: 192.168.1.4

 

Gateway: 192.168.1.1

 

Netmask: 255.255.255.0

For example, if the Ethernet name of the device is MGMT, the IP address is 
192.168.1.4

, the gateway is 10.4.2.1, and the subnet mask is 

255.255.255.255

, here is the command line to enter:

modify eth MGMT ip 192.168.1.4 gateway 10.4.2.1 netmask 
255.255.255.255

See 

 for more information about the 

Modify Eth command and configuring the management port.

2. See 

 to begin managing SANbox SSP 

remotely using the SANbox SSP Management GUI and the command line 
interface.

Once the management port has been properly configured, IP based 
management (telnet and web) can be accessed by using the newly defined IP 
address, or the default address of 192.168.1.4 if using a crossover cable.