Q-Logic Computer Drive 8200 SERIES ユーザーズマニュアル

3 – Getting Started with SANbox SSP

Setting Up SANbox SSP

SN0054628-00  A

3-7

Q

 

The SANbox SSP supports accessing the command line interface (CLI) through 
the serial console port. Once you have access to the CLI through the local console, 
you can modify the Ethernet settings to enable remote access to SANbox SSP 
through the SANbox SSP Management GUI or the CLI.

Please allow sufficient time (approximately 2 minutes) for SANbox SSP 
to load all the necessary drivers and system software and complete 
necessary Power-On Self Test (POST) diagnostics. 

Power on SANbox SSP by pressing the Main Power Switch on the port side.

The Main Power Switch should be illuminated, indicating the unit has begun the 
power on cycle. See 

 to view a picture of the port side of SANbox SSP.

While POST is in progress, the port status LEDs turn amber in color and flicker 
intermittently. POST is complete when the port LEDs turn off; this takes 
approximately 1-2 minutes. See 

 for more 

information.

You can also use the Main Power Switch to shut down the SANbox SSP. For more 
information, see 

1. Run a terminal emulation program such as HyperTerminal on the host computer. 

For best results, configure the terminal program for ANSI terminal 
emulation.

2. Configure the terminal on your host computer for 9600 baud, 8 data bits, no 

parity, 1 stop bit, and no flow control. 

1. Press the Enter key to get a prompt on your terminal emulation program.

2. If prompted, enter a login and password to gain administrative privileges. 

The default login is kadmin, and the default password is kahuna.

3. QLogic recommends that you change the password; run the Modify User 

command to change the password. See 

 

for more information.

Now that you are locally logged on to the command line interface (CLI), 
configure the Ethernet settings for remote access to SANbox SSP. See the 
next section,