Fujitsu CONNECT2AIR AP-600RP-USB ユーザーズマニュアル

CONNECT2AIR™ WLAN AP-600RP-USB

Page 20 / 62

6.5 Two AP-600RP-USB in repetition mode (WDS)

( 2 ) AP-600RP-USB Floor 1

( 3 ) AP-600RP-USB Floor 2

( 4 ) Notebook

WAN:

PPP over Ethernet

LAN:

static IP: 192.168.1.254

subnet Mask: 255.255.255.0

DHCP

on: 192.168.1.10 - 90

GW:

192.168.1.254

DNS:

auto

SSID: CONNECT2AIR
Channel: 11 (same as AP 2)
WDS:

MAC addr. of AP-600RP-USB 2

listed in the table

WAN:

no ISP

LAN:

static IP: 192.168.1.253

subnet Mask: 255.255.255.0

GW:

192.168.1.254

DHCP disabled
SSID: CONNECT2AIR
Channel: 11 (same as AP 1)
WDS:

MAC addr. of AP-600RP-USB 1

listed in the table

TCP/IP:

get IP and DNS

addresses
automatically
SSID: CONNECT2AIR
Data Rate: auto

The ADSL Modem (1) does not have to be configured.

Connecting the devices to the AP-600RP-USB:

AP-600RP-USB Floor 1

AP-600RP-USB Floor 2

Connect the ADSL Modem to the WAN port of the AP1, otherwise the PPPoE session
cannot be established and therefore the Internet service cannot be opened. Additional
networking devices like network printers, servers or scanners can be plugged into one of
the free LAN ports of the AP1 or AP2 and will be integrated in the IP segment of
192.168.1.X.

Installation Note

In order to have more range, up to 6 AccessPoints can be linked together. This case de-
scribes the configuration of linking two APs together where AP1 is the managing one,
which initiates the PPPoE session and acts as DHCP server. The SSID and the radio
channel must be equal for all APs linked, otherwise no connection can be established. Fur-
thermore, every AP has to know its counterpart, therefore a MAC address table is provided
to enter the appropriate AccessPoint.