Falcon MONITORING F110 ユーザーズマニュアル

www.rletech.com

24

970.484.6510

3

  F110 Web Interface

The Channel 2, Channel 3 and Channel 4 tabs are used to configure sensor labels and to set 

temperature thresholds, temperature/humidity thresholds and/or alarm states for the sensors 

connected to sensor channels 2, 3 and 4 on the front of the F110. Sensor labels can be up to 14 

characters in length. 

Depending on whether an external temperature / humidity sensor, external temperature sensor 

or any additional external sensor is plugged into the sensor channel, configuration of each 

specific channel may vary. 

High and low thresholds can be defined for each temperature/humidity sensor. If the current 

temperature and/or humidity rises above the high threshold or falls below the low threshold, an 

alert will be generated. When the temperature and/or humidity returns to a normal state, the alert 

will clear and a follow-up notification will be sent.

The temperature/humidity sensors can be calibrated, if necessary, by entering correction values 

in the Adjust field for each temperature/humidity sensor. Temperature corrections entered here 

can only be entered in degrees Celsius (i.e. °Celsius = [5/9]*[°Fahrenheit-32]). Humidity 

corrections are entered in percent (%) Relative Humidity. To adjust the temperature and/or 

humidity down, enter a minus (-) sign before the value (i.e. -5). All temperature alert thresholds 

must be entered in degrees Fahrenheit and all humidity alert thresholds must be entered in 

percent (%) Relative Humidity.

High

Fahrenheit

Low

Fahrenheit

Adjust

Celsius