Whirlpool MEDB850YG インストール手順

To reduce the risk of fire, this dryer MUST BE 

EXHAUSTED OUTDOORS.
IMPORTANT: Observe all governing codes and ordinances.

Dryer exhaust must not be connected into any gas vent, 

chimney, wall, ceiling, attic, crawlspace, or a concealed space 

of a building. Only rigid or flexible metal vent shall be used for 

exhausting.

 

■

Only a 4" (102 mm) heavy metal exhaust vent and clamps  

may be used. 

 

■

Do not use plastic or metal foil vent.

 

■

Recommended for best drying performance and to avoid 

crushing and kinking.

(Acceptable only if accessible to clean)

 

■

Must be fully extended and supported in final dryer location.

 

■

Remove excess to avoid sagging and kinking that may  

result in reduced airflow and poor performance.

 

■

Do not install in enclosed walls, ceilings, or floors.

 

■

The total length should not exceed 7

3

/

4

 ft. (2.4 m).

If using an existing vent system, clean lint from  

entire length of the system and make sure exhaust hood  

is not plugged with lint. Replace plastic or metal foil vents  

with rigid metal or flexible metal vents. Review Vent System  

Chart and if necessary, modify existing vent system to  

achieve best drying performance.

4" (102 mm) heavy metal exhaust vent

C

B

E

Connect neutral ground wire (E) and neutral wire (white or 

center wire) (C) of power supply cord or cable under center 

terminal block screw (B). Tighten screw.

Place hooked ends of remaining wires under outer terminal 

block screws (hooks facing right). Tighten screws. 

A

G

Connect a separate copper ground wire (G) from the external 

ground conductor screw (A) to an adequate ground. Finally, 

reinsert tab of terminal block cover into slot of dryer rear 

panel. Secure cover with hold-down screw. Now, go to 

“Venting Requirements.”