Gaggenau AR400742 インストールガイド
6
General notes
Ventilation line
Note: The appliance manufacturer does not assume any
warranty for complaints attributable to the pipe section.
warranty for complaints attributable to the pipe section.
▯
The appliance achieves its optimum performance by
means of a short, straight exhaust air pipe and as
large a pipe diameter as possible.
means of a short, straight exhaust air pipe and as
large a pipe diameter as possible.
▯
As a result of long rough exhaust air pipes, many
pipe bends or pipe diameters that are smaller than
6" (150 mm), the optimum extraction performance is
not achieved and fan noise is increased.
pipe bends or pipe diameters that are smaller than
6" (150 mm), the optimum extraction performance is
not achieved and fan noise is increased.
▯
The pipes or hoses for laying the exhaust air line
must be made of non-combustible material.
must be made of non-combustible material.
▯
Use sealing strip for deviating pipe diameters.
Electrical Requirements
This appliance must be properly installed and grounded
by a qualified technician in accordance with the
National Electrical Code ANSI/ NFPA 70 (latest edition)
and local electrical code requirements. IN CANADA:
Electrical installation must be in accordance with the
current CSA C22.1 Canadian Electrical Codes Part1
and/or local codes.
by a qualified technician in accordance with the
National Electrical Code ANSI/ NFPA 70 (latest edition)
and local electrical code requirements. IN CANADA:
Electrical installation must be in accordance with the
current CSA C22.1 Canadian Electrical Codes Part1
and/or local codes.
The range must be connected to the proper electrical
voltage and frequency as specified on the rating plate.
voltage and frequency as specified on the rating plate.
For wall mounting: Checking the wall
▯
The wall must be level, vertical and adequately load-
bearing.
bearing.
▯
Use suitable fasteners depending on the type of
construction (e.g. massive brickwork, drywall,
porous concrete, Poroton wall tiles).
construction (e.g. massive brickwork, drywall,
porous concrete, Poroton wall tiles).
▯
The depth of the bore holes must be the same
length as the screws. The wall plugs must have a
secure grip.
length as the screws. The wall plugs must have a
secure grip.
▯
The maximum weight of the fan module is
approx. 9 kg
.
Before You Begin
Tools and Parts Needed
▯
Screwdriver Torx T20
▯
Pencil
▯
Drill with ¼" (6 mm) bit
▯
Jigsaw
▯
Tape Measure
Note: Additional materials may be necessary for
installation in solid surface countertops. Contact the
countertop manufacturer.
installation in solid surface countertops. Contact the
countertop manufacturer.
Additional parts needed:
▯
1 inch 3-wire conduit
▯
1 inch cable/cord connector
Parts Included