Whirlpool WDF760SADM クイック設定ガイド

Connect wires black to black and white to white, using UL 
Listed/CSA Approved twist-on wire connectors.

If needed, see website for animated representation of this step. 
Visit www.whirlpool.com/electrical under FAQ tab.

Tighten strain relief screws to secure cord.

Place wires inside terminal box. Insert tabs on left side of cover. 
Make sure wires are tucked inside box. Close cover ensuring 
wires are not pinched. Use 

¹⁄₄" hex-head socket, nut driver or 

Torx

®

 T20

®

 screwdriver and previously removed screw to secure 

cover.
NOTE: Do not plug into outlet until instructed to do so. 

Measure height of cabinet opening from underside of countertop 
to floor where dishwasher will be installed (you will need to 
measure the lowest point on the underside of the countertop and 
the highest point on the floor). Refer to “Dishwasher Height 
Adjustment Chart” for wheel position and the number of turns 
needed.

NOTE: If the minimum cabinet opening height is less than 34" 
(86.4 cm), the rear wheels can be removed for additional 
clearance. This will allow the dishwasher to fit into a 33

¹⁄₂" 

(85.1 cm) high cabinet opening, but the dishwasher will be more 
difficult to move. (Measurements are approximate. Wheels and 
legs are preset at the factory for 34

¹⁄₂" [87.6 cm].)

Turn both leveler legs to the same height. Put wheels in the 
required position determined from “Dishwasher Height 
Adjustment Chart.”