Electrolux UR15IM20RS オーナーマニュアル

8

Observe and follow all local plumbing 

codes when installing this appliance. 

After completing the installation, turn 

on the water and recheck the drain 

and water connections for leaks.

This ice machine must be connected to a 

potable cold water supply line delivering 

water pressure between a minimum of 20 

psi and a maximum of 120 psi.
Use 1⁄4" copper tubing for your water 

supply which is available at any local 

hardware or plumbing supply store. 

Route the 1⁄4" copper tubing to suit your 

installation being sure not to kink the 

tubing. Purchase enough copper tubing 

length to allow a coil to be formed behind 

the unit for a "service loop" which will allow 

the appliance to be pulled out from the 

installation for servicing or cleaning (Figure 

5). Connect the copper tubing to the "top 

side" of a cold water pipe to prevent the 

ice-maker from plugging with sediment. 
A shutoff valve is recommended on the 

water supply line to ease servicing the 

appliance. NOTE: A SELF-PIERCING 

TYPE VALVE IS NOT RECOMMENDED as 

they are prone to clogging with sediment 

which will create pressure drop reducing 

the water supply to the unit. 
Connect the copper tubing water supply to 

the water valve inlet with the compression 

nut fitting provided. Secure the water 

supply line to the back of the cabinet with 

the screw and strain relief clamp provided 

in the corner of the back panel (Figure 5).
Make certain all connections are watertight 

after installation. Form the tubing so that it 

will not vibrate against the cabinet body or 

kink when your appliance is moved in and 

out of position.
This ice machine is designed to make 

clear ice from the majority of water 

sources on a daily basis. If your results are 

unsatisfactory, your water may need to be 

filtered or treated. A water specialist can 

recommend proper water treatment.

•  The water line fitting is to be used 

with copper tubing only. Do not 

use with plastic tubing since it 

may crack or rupture with age.

•  Do not use any thread sealers on 

this water line fitting.

•  Reverse osmosis, (RO), water, 

softened water, and de-ionized 

water are not recommended as 

they will adversely affect the 

quality of the ice.

Figure 5 Back view of ice machine

Water supply

service loop

(to shut 

off valve)

Water

supply

line

Compression

fitting

Water valve

inlet

Water Supply

Line

Clamp and

Screw

Once all connections have been made, 

plug in the power cord and gently push 

the unit into position. Allow at least 

1-1/2 inches clearance behind the unit 

for electrical, water supply and drain 

connections.