Tascam CC-222MKIV ユーザーズマニュアル
1 – Introduction
30
TASCAM CC-222
MK
IV
7 – Cassette operating
Note the following when loading tapes:
1 Use your finger or a pencil to turn the cassette's hub
1 Use your finger or a pencil to turn the cassette's hub
and take up any slack tape.
NOTE
Avoid touching the tape. Fingerprints attract dust and
dirt.
dirt.
2 Press the
EJECT
key to open the cassette compart-
ment door.
3 Load the cassette tape with its open edge facing
down.
4 Gently close the compartment door.
NOTE
The cassette holder cannot be opened during record-
ing or playback.
ing or playback.
If the power has been switched off during play or
recording, ejecting the cassette may be impossible. In
such a case, switch the power on and press the EJECT
key again.
recording, ejecting the cassette may be impossible. In
such a case, switch the power on and press the EJECT
key again.
Continuous tape/CD playback
1 Load the tape as described above into the unit.
Load the disc recorded side downwards into the
unit.
2 Press the
CD-TAPE CONT PLAY
key.
3 Press either of the
PLAY
keys of the tape deck or the
CD deck.
Playback will start on the appropriate unit. When
playback reaches the end of the disc, or the end of
the tape as determined by the
REV MODE
setting,
playback starts on the other unit.
NOTE
Media (tape or disc) can be changed in the unit that is
not playing.
not playing.
4 To stop playback and cancel the mode, press the
CD-TAPE CONT PLAY
key again.
NOTE
The cassette deck and CD deck can be used to play
back through different outputs, or the LINE OUTPUTS
2 jacks can be used for both disc and tape playback
(see “OUT2 setting (TAPE or AUTO)” on page 33 for
details). However, note that if both are playing, the
cassette takes priority (the disc will not be heard
through these outputs).
back through different outputs, or the LINE OUTPUTS
2 jacks can be used for both disc and tape playback
(see “OUT2 setting (TAPE or AUTO)” on page 33 for
details). However, note that if both are playing, the
cassette takes priority (the disc will not be heard
through these outputs).
The LINE OUTPUTS1 jacks always output the audio
from th edisc.
from th edisc.
Playback operations
WARNING
If you are monitoring using headphones, first adjust
the level control to low on the unit, then connect to the
POHNES jack before playing back. This will prevent
any possible damage to your hearing.
the level control to low on the unit, then connect to the
POHNES jack before playing back. This will prevent
any possible damage to your hearing.
1 Set the
REV MODE
switch to the required tape
mode.
Ä
Single-sided playback
Ë
One side, then the other side, then stop
ä
One side, then the other side, then the first side
again, etc.
Also, check the
MONITOR
switch is set to
TAPE
.
2 Load a pre-recorded cassette with its open edge fac-
ing down and side A facing toward you.
3 Press either
PLAY
key to start playback.
4 Adjust the volume with the amplifier’s volume control.
5 To stop playback, press the
5 To stop playback, press the
STOP
key.