DISH Network Solo 351 ユーザーガイド

5. Turn on the nearby TV. 

6. Tune the TV to channel 3.

7. You should see the 

screen.

8. If you do not see the correct screen, tune the TV to channel 4.

: If you want to change the channel that the 

 connection 

provides to your TV, see Changing the TV1 and TV2 Output Channels 

on page 26.

9. If desired to remind you of which TV channel (3 or 4) to tune to watch 

satellite programming, place one of the channel stickers (3 or 4) near or 

on your TV.

1. Connect one of the following video cables:

video cable (yellow) from the receiver TV1 outputs to the 

nearby TV’s 

 video input.

•

 cable from the receiver TV1 outputs to the nearby TV’s 

 input. 

2. Connect the 

 audio cables (red and white) from the receiver TV1 

outputs to the nearby TV’s audio inputs. If the TV has only one input for 

this type of audio, connect it to the right (R) phono (RCA) audio output 

on the receiver.

3. Make sure your nearby TV is on and set to receive TV from the correct 

audio and video inputs. Refer to the instructions that came with your TV.

4. Plug in the power cord for the receiver. 

5. Turn on the receiver with the front panel power button and make sure the 

green TV1 indicator is lit.

6. You should see the 

 screen.

After the nearby TV has been connected to a TV1 output using one of the 

methods above, do the following to confirm that the IR Remote Control 1 

controls the receiver:

1. Make sure that fresh batteries are installed properly in the IR Remote 

Control 1. 

2. Press the SAT button to put the IR Remote Control 1 in SAT mode to 

control the satellite receiver.

3. Use the Remote Control 1 arrow keys to move around the 

screen. If you are able to move around in the 

screen, you 

confirmed that Remote Control 1 is controlling the receiver.