DISH Network Solo 351 ユーザーガイド

ページ / 137
Chapter 2
Page 22
Receiver Description and Installation
1. Connect 
CH 21-69 O
UT
 on the receiver to your existing wall cable outlet 
using a coaxial cable.
Note
If you do not have an existing in-home cable system, you 
will need to run coaxial cable to each TV in other rooms. If this is 
too difficult, you may want to contact a professional to do this 
installation.
2. Place the yellow sticker on the 
CH 21-69 O
UT
 cable near where the cable 
attaches to the receiver. See the tip in the margin.
3. Make sure batteries are installed in Remote Control 2 and the UHF 
antenna is attached to 
R
EMOTE
 A
NTENNA
 port on the receiver. 
4. Make sure the receiver's blue TV2 indicator is off. If it is on, turn it off 
by doing the following:
a. Press the SAT mode button on Remote Control 2 to put the remote 
control in SAT mode.
b. Press the POWER button on Remote Control 2 and make sure the 
receiver's TV2 blue indicator turns off.
5. Connect the tuner input of the remote TV(s) in other rooms to an 
existing wall cable outlet using a coaxial cable.
6. Turn on every remote TV connected to the in-home cabling system. 
7. Find three channels next to each other on one of your remote TVs that 
do not pick up any signals from off-air or cable broadcasts (they should 
show nothing but snow or static). These channels must fall in one of the 
two ranges below. For example, if you find that cable channels 75, 76, 
and 77 do not pickup any broadcasts, pick these channels since they fall 
into the range below for cable channels. Make sure these three channels 
on other remote TVs also do not pick up broadcasts.
Air Mode
 - Select a channel between 21 and 69.
Cable Mode
 - Select a channel between 73 and 125.
Note
: The remote TV(s) will have to be set to the same channel mode, 
either off-air or cable channel mode for this installation. See your TV 
user guide for instructions on how to set your TV to off-air or cable 
channel modes.
8. Pick the channel in the middle of the three you selected in step 7. Write 
that channel down in the blank provided in the margin. For example, if 
the three channels you picked in the preceding step were cable channels 
75, 76, and 77, pick channel 76 and write it in the margin.
Make sure you are familiar with how to change channels on
your TV and if necessary how to switch your TV between
off-air and cable channels. During this procedure, it will be
necessary to change the channels on your TV(s) to tune to
these channels to see the video from the receiver. See your
TV user guide for instructions.
Tip: Using cable 
labels makes it 
easy to tell which 
cables connect to 
the receiver ports. 
Inside the front 
cover of this guide 
are stickers that 
are color coded the 
same way as the 
coaxial 
connections. 
Channel:
Air/Cable: