DISH Network Solo 351 ユーザーガイド

This section describes how to connect the receiver 

connection to the cable-ready remote TV located in another room away 

from the receiver. This installation uses your in-home cable system. If your 

house does not have built-in cabling, it will be necessary to run cables from 

the receiver to each remote TV. Due to the difficulty of this installation, you 

should consider having this professionally installed. Call DISH Network at 

1-800-333-DISH (3474).

: When connecting to the home distribution (

) coaxial 

port, you must meet the FCC requirements in the Appendix. To meet these 

requirements, an in-line coaxial attenuator has been included with your 

receiver and may need to be installed using the following guidance: 

•

If connecting to your in-home cabling system to distribute the signal to 

a TV(s) in other rooms, in most cases you will not have to install the 

attenuator on the 

 port for typical in-home cabling systems. 

•

If connecting directly to a TV tuner port, you must install the attenuator 

in the cable between the 

 port and the TV tuner.

If you have an off-air antenna or cable connected to your in-

home cable system, see Optional - Connecting to an Off-

Air Antenna or Cable following this section.