Patton electronic SmartNode 4110 Series ユーザーズマニュアル

Ethernet port configuration task list

SmartWare Software Configuration Guide 

Mode: Configure

By default no VLAN ports are configured on an Ethernet port. One or more VLAN ports can be created on 
each Ethernet port.

You must bind the VLAN port to an existing IP interface. When executing the 

 command, the requested 

interface must exist.

For incoming VLAN packets each of the 8 possible layer 2 class of services (CoS) can be mapped to a traffic 
class. Unless otherwise specified all CoS values map to the default traffic class.

By default all VLAN ports are initially disabled. They can be enabled with the 

 command. The 

corresponding Ethernet port must also be enabled for the VLAN port to work. If the Ethernet port is disabled, 
all associated VLAN ports are also disabled.

When a VLAN port is closed, the IP interface that is bound to this port is also closed. All static routing entries 
that are using this interface change their state to invalid and all dynamic routing entries will be removed from 
the route table manager.

Enter the IP context configuration 
mode.

[name] (ctx-ip)[router]# interface <ip-if-1-name>

Create the first IP interface.

[name] (if-ip)[ <ip-if-1-name>]# ipaddress <ip-
address-1> <subnet-mask-1>

Set the IP address for the first IP inter-
face

[name] (if-ip)[ <ip-if-1-name>]# interface <ip-if-2-name>

Create the second IP interface.

[name] (if-ip)[ <ip-if-2-name>]# ipaddress <ip-address-2> 
<subnet-mask-2>

Set the IP address for the second IP 
interface

[name] (if-ip)[ <ip-if-2-name>]# port ethernet <slot> 
<port>

Enter Ethernet port configuration 
mode

[name] (prt-eth)[<slot>/<port>]# encapsulation ip

Set the encapsulation to IP

[name] (prt-eth)[<slot>/<port>]# bind interface <ip-if-
1-name>

Bind the port to the first IP interface

[name] (prt-eth)[<slot>/<port>]# bind interface <ip-if-
2-name>

Bind the port to the second IP inter-
face

10 [name] (prt-eth)[<slot>/<port>]# no shutdown

Enable the Ethernet port