Patton electronic SmartNode 4110 Series ユーザーズマニュアル

Ethernet port configuration task list

SmartWare Software Configuration Guide 

Mode: Configure

To enable to transport real-time and delay sensitive services such as VoIP traffic across the network, the firm-
ware application software supports the delivery of Quality of Service (QoS) information in the ToS (Type of 
Service) field. This is an eight-bit field, the second field in the IP header packet. To define the Class of Service 
(CoS) to service class mapping, the 

 command is used, with one of the following arguments:

•

default—Default service class when no Layer 2 CoS present

•

rx-map—Receive mapping table - Layer 2 CoS to service class mapping

•

tx-map—Transmit mapping table - Service class to Layer 2 CoS mapping

This procedure describes how to change layer 2 CoS to service class mapping.

Enter Ethernet port configura-
tion.

Create new VLAN port.

Defines the payload type(s) to 
be used on this VLAN: 
• ip: IP traffic only (not used 

for PPP) 

• pppoe: PPPoE sessions only 
• multi: both IP traffic and 

PPPoE sessions 

For more information on the 
PPP/PPPoE configuration see 
chapter 30,

Bind the VLAN port to the exist-
ing interface name. If no IP con-
text is given, the system attaches 
the interface to the default IP 
context known as router.

Selects the layer 2 CoS (Class of 
Service) to traffic class map-
ping. The traffic class must 
already exist.

Activate the VLAN port.

node(vlan)[id]#exit node(prt-eth)[slot/port]# no shutdown Make sure the hosting Ethernet 

port is also activated.