Patton electronic SmartNode 4110 Series ユーザーズマニュアル

Ethernet port configuration task list

SmartWare Software Configuration Guide 

Mode: Configure

If the frame format is set to standard, the 

 command value defines which class of service to use for 

the data traffic.

The 

 and 

 commands above need service class mapping table entries, which has to be 

entered as additional command argument. The command syntax is:

•

cos rx-map—layer 2 class of service value as service class value

•

cos tx-map—service class value as layer 2 class of service value

Do the following to configure the class of service map:

1. Configure the class of service map table for the outgoing data traffic. Every provided service can be 

mapped to a Class of Service.

2. Configure the class of service map table for the incoming data traffic. Every received Class of Service can be 

assigned to a service type.

Adding a receive mapping table entry
The receive mapping table defines the conversion of receiving Layer 2 CoS to service class value into a firm-
ware-specific service class value. Each conversion is stored as a mapping table entry, so the receive mapping 
table consists of several mapping table entries. 

This procedure describes how to add a receive mapping table entry.

Mode: Configure

Example: Adding a receive mapping table entry 

The following example shows how to add a receive mapping table entry, which converts a layer 2 class of ser-
vice value of 2 into a service class value of 4 for the Ethernet port on slot 0 and port 0 of a SmartNode.

node(cfg)#port ethernet 0 0
node(prt-eth)[0/0]#cos rx-map 2 as 4

Enters Ethernet port configura-
tion mode for the interface on 
slot and port

Selects the layer 2 CoS to traffic-
class mapping. The traffic class 
name can be freely chosen.

Enters Ethernet port configuration mode for the 
interface on slot and port.

Adds a receive mapping table entry, which con-
verts a layer 2 class of service into a service class 
value.