Patton electronic SmartNode 4110 Series ユーザーズマニュアル

RIP configuration task list

SmartWare Software Configuration Guide 

Example: Enabling send RIP 

The following example shows how to enable send RIP on IP interface wan.

node(cfg)#context ip router
node(ctx-ip)[router]#interface wan
node(if-ip)[wan]#rip supply

By default an interface does not listen to routing information. This procedure describes how to enable interface 
to receive RIP information

Mode: Interface

Example: Enabling receive RIP 

The following example shows how to enable receive RIP on IP interface wan.

node(cfg)#context ip router
node(ctx-ip)[router]#interface wan
node(if-ip)[wan]#rip receive

By default, RIP 1compatible packets are sent. Alternatively, you can explicitly configure the RIP version to be 
sent with the last command argument as following:

•

1—RIPv1

•

1compatible—RIPv1 compatible

•

2—RIPv2

This procedure describes how to select the sending RIP version on interface

Mode: Interface

Example: Specifying the send RIP 

The following example shows how to select send RIP version 1compatible on IP interface wan.

node(cfg)#context ip router
node(ctx-ip)[router]#interface wan
node(if-ip)[wan]#rip send version 1compatible

Enables receive RIP on interface name

node(if-ip)[name]# rip send version {1 | 1compatible | 2} Selects send RIP version for inter-

face name