Patton electronic SmartNode 4110 Series ユーザーズマニュアル

RIP configuration task list

SmartWare Software Configuration Guide 

By default, RIP version 1 and version 2 packets are received. Alternatively, you can explicitly configure the RIP 
version to be received with the last command argument as following:

•

1—to receive RIP version 1 packets

•

1or2—to receive RIP version 1 and version 2 packets

•

2—to receive RIP version 2 packets

This procedure describes how to set receiving RIP version on an interface

Mode: Interface

Example: Specifying the receive RIP 

The following example shows how to select receive RIP version 1or2 on IP interface wan.

node(cfg)#context ip router
node(ctx-ip)[router]#interface wan
node(if-ip)[wan]#rip receive version 1or2

A new route is added to the local routing table, if the routing update contains a route to a destination that does 
not already exist. If the update describes a route whose destination is already in the local table, the new route is 
used only if it has a lower cost. The cost of a route is determined by adding the cost of reaching the gateway 
that sent the update to the metric contained in the RIP update packet. If the total metric is less than the metric 
of the current route, the new route is used. Two RIP learning mechanisms are offered, which are represented by 
a specific argument of the command 

:

•

host—for RIP learn host and

•

default—for RIP learn default

See the following sections on how to configure those two RIP learning mechanisms.

This procedure describes how to enable accepting of IP host and default routes received on an interface for 
RIP learning

Mode: Interface

Example: Enabling RIP learn host and default

node(if-ip)[name]# rip receive version {1 | 1or2 | 2} Selects receive RIP version for interface 

Enables accepting of IP host routes received on interface 
name

node(if-ip)[name]#rip learn default Enables learning using a default route advertised by an RIP 

neighbor on interface name