Patton electronic SmartNode 4110 Series ユーザーズマニュアル

RIP configuration task list

SmartWare Software Configuration Guide 

node(cfg)#context ip router
node(ctx-ip)[router]#interface wan
node(if-ip)[wan]#rip announce default
node(if-ip)[wan]#rip announce host

Summarizing routes in RIP Version 2 improves scalability and efficiency in large networks.

Auto-summarization attempts to automatically summarize groups of adjacent routes into single entries, the 
goal being to reduce the total number of entries in the RIP routing table, reducing the size of the table and 
allowing the router to handle more routes. 

RIP auto-summarization (automatic network number summarization) is disabled by default. With auto-sum-
marization, the SmartNode summarizes sub prefixes to the Class A, Class B, and Class C network boundary 
when class network boundaries are crossed.

This procedure describes how to enable RIP auto-summarization on an interface

Mode: Interface

Example: Enabling RIP auto-summarization 

The following example shows how to enable auto-summarization on IP interface wan.

node(cfg)#context ip router
node(ctx-ip)[router]#interface wan
node(if-ip)[wan]#rip auto-summary

RIP uses a single routing metric (hop count) to measure the distance between the source and a destination net-
work. Each hop in a path from source to destination is assigned a hop-count value, which is typically 1. When 
a SmartNode receives a routing update that contains a new or changed destination-network entry, the Smart-
Node adds one to the metric value indicated in the update and enters the network in the routing table. The IP 
address of the sender is used as the next hop.

RIP prevents routing loops from continuing indefinitely by implementing a limit on the number of hops 
allowed in a path from the source to a destination. The maximum number of hops in a path is 15. If a Smart-
Node receives a routing update that contains a new or changed entry, and if increasing the metric value by one 
causes the metric to be infinity (i.e. 16), the network destination is considered unreachable.

Because metrics cannot be directly compared, you must specify the default metric in order to designate the cost 
of the redistributed route used in RIP updates. All routes that are redistributed will use the default metric.

Setting the default route metric, which is a number, indicating the distance to the destination network ele-
ment, e.g. another router or SmartNode in a network, is possible with the 

 command. 

The value is between 1 and 15 for a valid route, or 16 for an unreachable route.

This procedure describes how to set the routing metric on an interface

node(if-ip)[name]#rip auto-summary Enables RIP auto-summarization on interface name