ユーザーガイド目次JPM-13CS Planer-Molder11.0 Warranty and Service22.0 Table of contents33.0 Safety warnings44.0 About this manual55.0 Electrical connections65.1 Grounding instructions65.2 115 Volt operation65.3 230 Volt operation66.0 On-Off Switch Padlock77.0 Specifications88.0 Glossary99.0 Setup and assembly109.1 Shipping contents109.2 Unpacking and cleanup109.3 Assembly1010.0 Adjustments: Planing1010.1 Depth of cut1010.2 Adjusting depth of cut scale1010.3 Feed rate adjustment1110.4 Adjusting V-Belt Tension1110.5 Knife adjustment1110.6 Knife replacement1210.7 Adjusting infeed roller and outfeed rollers for planing1210.8 Adjusting chip deflectors for planing1311.0 Planing procedure1311.1 Dealing with warped wood1311.2 Wood Grain1412.0 Molding setup and adjustments1412.1 Installing molding cutters1412.2 Setting feed rollers for molding1512.3 Making & installing a bedboard1612.4 Making guide rails1612.5 Guide rail placement and attachment1613.0 Molding procedure1713.1 Setting table height for first pass1713.2 Back Relief Molding1813.3 Tongue and Groove Molding1814.0 Maintenance1814.1 Lubrication1815.0 Troubleshooting the JPM-13CS1915.1 Mechanical and electrical problems1915.2 Performance problems2016.0 Replacement Parts2116.1.1 Table and Base Assembly – Exploded View2216.1.2 Table and Base Assembly – Parts List2316.2.1 Cutterhead and Roller Assembly – Parts List2416.2.2 Cutterhead and Roller Assembly – Parts List2416.3.1 Gearbox Assembly – Parts List2616.3.2 Gearbox Assembly – Parts List2716.4.1 Stand and Motor Assembly – Parts List2816.4.2 Stand and Motor Assembly – Parts List2917.0 Electrical Connections30サイズ: 1.01MBページ数: 32Language: Englishマニュアルを開く