Generac Power Systems H-100 사용자 설명서

Press the “ENTER” button.

Press the “ENTER” button.

The above two pages are typical of communications 
diagnostics, one page for each port. The LCD display 
will show four lines of information about the port:

LINE 1:  Will show the type of port protocol that has 
been selected. It will also show the Modbus address 
(if appropriate) and whether the port is RS-232 or 
RS-485.

LINE 2:  Will show the settings for the port such as 
baud rate, bits per character, stop bits, and parity. 

LINE 3:  Shows a live update of counts of messages 
transmitted, received, and errors.

LINE 4:  Shows a mimic of LED’s for TX, RX, and 
ERR. For example, the TX LED lit (T*) means the H-
100 Control Panel is transmitting. Not lit (T-) means 
it is not transmitting.

There are four pages under this menu item – two for 
internal exercise and two for HTS. This is where the 
internal exercise can be setup and enabled (see the 
Exercise Setup Using Front Panel section) and the 
HTSs can be enabled and monitored. 

Do the following to view the internal exercise and 
HTS pages:

Press the “MENU” button.

Press the 

 button.

Press the “ENTER” button.

This is a typical first Internal Exercise and HTS 
page.

LINE 1: Indicates if internal exercise is enabled. This 
field is editable. 

LINE 2:  Day of week and time of day to start the 
exercise weekly. These fields are editable. 

LINE 3:  How much time remains before exercise is 
completed. It starts with 20 minutes.

LINE 4:  The “More” field to allow page selection.

Press the “ENTER” button.

This is a typical second Internal Exercise and HTS 
page. 

LINE 1:  Indicates if QuietTest® is enabled. This field 
is editable.

LINE 2:  Can be used to start a 20 minute exercise 
period right now. This field is editable.

LINE 3: Indicates if the HTS switches should be 
exercised during normal exercise mode. This field is 
editable.

LINE 4:  The “More” field to allow page selection.

Press the “ENTER” button.

  

21