Sony STRDH520 사용자 설명서
67
GB
D:\NORM'S JOB\SONY HA\SO0109\STR-DH520\4263361111_GB\GB09REM_STR-DH520-
U2.fm
U2.fm
masterpage: Right
STR-DH520
4-263-361-11(1)
Ad
ditional Inf
ditional Inf
o
rmation
When the receiver is in standby mode,
there is no image output from the TV.
there is no image output from the TV.
• When the receiver enters into standby
mode, image are from the last HDMI
equipment selection before you turned off
the receiver. If you are enjoying other
equipment, play the equipment and
perform the One-Touch Play operation, or
turn on the receiver to select the HDMI
equipment you want to enjoy.
equipment selection before you turned off
the receiver. If you are enjoying other
equipment, play the equipment and
perform the One-Touch Play operation, or
turn on the receiver to select the HDMI
equipment you want to enjoy.
• Make sure “PASS.THRU” is set to “ON”
in the HDMI menu if you connect
equipment not compatible with the
“BRAVIA” Sync to the receiver (page 60).
equipment not compatible with the
“BRAVIA” Sync to the receiver (page 60).
Recording cannot be carried out.
• Check that the equipment are connected
correctly.
• Select the source equipment using the
input buttons (page 36).
The FM reception is poor.
• Use a 75-ohm coaxial cable (not supplied)
to connect the receiver to an outdoor FM
antenna (aerial) as shown below.
antenna (aerial) as shown below.
Radio stations cannot be tuned in.
• Check that the antennas (aerials) are
connected securely. Adjust the antennas
(aerials) and connect an external antenna
(aerial), if necessary.
(aerials) and connect an external antenna
(aerial), if necessary.
• The signal strength of the stations is too
weak with automatic tuning. Use direct
tuning.
tuning.
• Make sure you set the tuning scale
correctly (when tuning in AM stations
with direct tuning) (page 40).
with direct tuning) (page 40).
• No stations have been preset or the preset
stations have been cleared (when tuning by
scanning preset stations is used). Preset the
stations (page 41).
scanning preset stations is used). Preset the
stations (page 41).
• Press DISPLAY repeatedly so that the
frequency appears on the display panel.
RDS does not work.*
• Make sure that you are tuned to an FM
RDS station.
• Select a stronger FM station.
The RDS information that you want
does not appear.*
does not appear.*
• The service may be temporarily out of
order. Contact the radio station and find
out whether they actually provide the
service in question.
out whether they actually provide the
service in question.
* Europe, Australia and Taiwan models only.
The remote control does not function.
• Point the remote control at the remote
control sensor on the receiver.
• Remove any obstacles in the path between
the remote control and the receiver.
• Replace all the batteries in the remote
control with new ones, if they are weak.
• Make sure you select the correct input on
the remote control.
Tuner
Receiver
Outdoor FM antenna (aerial)
Remote control