Nortel Networks 4050 사용자 설명서
Chapter 10 Configuring system settings 465
Nortel Secure Network Access Switch 4050 User Guide
Configuring the Nortel SNAS 4050 host using the CLI
To configure basic TCP/IP properties for a particular Nortel SNAS 4050 device in
the cluster, use the following command:
the cluster, use the following command:
/cfg/sys/host <host ID>
where
host ID
is an integer automatically assigned to the host when you
perform initial setup on the Nortel SNAS 4050 device.
The
/cfg/sys/host <host ID>
command also allows you to halt, reboot, or
delete the specified Nortel SNAS 4050 device.
The Cluster Host menu displays.
accesslist
Accesses the Access List menu, in order to control
Telnet and SSH access to Nortel SNAS 4050 devices
(see
Telnet and SSH access to Nortel SNAS 4050 devices
(see
adm
Accesses the Administrative Applications menu, in
order to set the CLI timeout value; manage Telnet,
SSH, SNMP, and SONMP access to Nortel SNAS 4050
devices; enable SRS administration; generate SSH
host keys; and configure the system for RADIUS
auditing and authentication of system users (see
order to set the CLI timeout value; manage Telnet,
SSH, SNMP, and SONMP access to Nortel SNAS 4050
devices; enable SRS administration; generate SSH
host keys; and configure the system for RADIUS
auditing and authentication of system users (see
user
Accesses the User menu, in order to manage users
and passwords (see
and passwords (see
distrace
Permanently disables the
/cfg/domain #/server/trace/ssldump
and
/cfg/domain #/server/trace/tcpdump
commands (see
The
distrace
command is used to improve security.
The only way to reverse this command is to do a boot
install.
install.
/cfg/sys
followed by: