Netgear WNR1000v3h2 사용자 설명서

If you choose to use WPS, the only security methods supported are 

WPA-PSK and WPA2-PSK. WEP security is not supported by WPS.

The WNR1000v3h2 router provides two methods for connecting to a wireless client that 
supports WPS, described in the following sections: 

Push Button Configuration

There are two methods to enable a wireless client to join a network using a push button on 
the router: using the physical push button or using the software button in the Add WPS Client 
screen.

Press the button on the rear of the WNR1000v3h2 router for over 5 seconds. For 

information about the WPS light, see the NETGEAR Wireless Router Setup Manual.

The green 

 light begins to blink in a regular pattern. While the light is blinking, you 

have 2 minutes to enable WPS on the client that you are trying to connect to the router.

On the wireless client, follow its specific networking instructions to enable WPS, to allow it to 

connect to the router.

The WNR1000v3h2 router’s green 

 light ceases blinking and remains on when one of 

these conditions occurs:

The router and the client establish a wireless connection.

The 2-minute window period expires for establishing a WPS connection. If the 

connection is not established, the SSID and security settings will not be changed.

Using the Software Button in the Add WPS Client Screen

7.

Select Add WPS Client in the main menu, and click Next.

Select the Push Button setup method.