Netgear WNR1000v3h2 사용자 설명서

The Internet status light on the wireless router is on if the Ethernet cable connecting the 

wireless router and the modem is plugged in securely and the modem and wireless router 
are turned on. 

For each powered-on computer connected to the wireless router by an Ethernet cable, 

the corresponding numbered router LAN port light is on. 

For a wirelessly connected computer, the wireless network name (SSID) and WEP or 

WPA security settings of the router and wireless computer must match exactly. 

If you have enabled the wireless router to restrict wireless access by MAC address, you 

must add the wireless computer’s MAC address to the router’s wireless card access list.

LAN connected computers must be configured to obtain an IP address automatically 

using DHCP. For more information, see the links in 

.

Some cable modem services require you to use the MAC address of the computer 

registered on the account. If so, in the Router MAC Address section of the Basic Settings 
menu, select Use this Computer’s MAC Address. Click Apply to save your settings. 
Restart the network in the correct sequence. 

If the Test light does not turn off within 2 minutes after you turn the router on, reset the router 
according to the instructions in 

100.

Troubleshooting Basic Functions

After you turn on power to the router, the following sequence of events should occur:

When power is first applied, verify that the Power light 

is on.

Verify that the power light turns amber within a few seconds, indicating that the self-test 

procedure is running.

After approximately 1 minute, verify that:
a. The color of the power light changes to green.
b.  The LAN port lights are lit for any local ports that are connected.

If a port’s light is lit, a link has been established to the connected device. If a LAN port 
is connected to a 100 Mbps device, verify that the port’s light is green. If the port is 10 
Mbps, the light will be amber.

c.  The Internet port is connected and its light is lit.