Netgear WNR1000v3h2 사용자 설명서

The Internet is not accessible. Confirm that you have the correct internet setting. 

Clear the router’s configuration to factory defaults. This will set the router’s IP address to 

Turn the power off and back on, and re-configure the router, to see if the router recovers.

If either the LAN or Internet lights do not light when the Ethernet connection is made, check 
the following:

Make sure that the Ethernet cable connections are secure at the router and at the 

computer.

Make sure that power is turned on to the connected computer.

Be sure you are using Ethernet cables like the cable that was supplied with the wireless 

router. See the NETGEAR Wireless Router Setup Manual for instructions.

If after using the WPS function the push-button blinks, check the following:

Make sure that you are using the push-button (see 

Make sure you have not pushed the push-button after disabling the WPS function (you 

logged into the router and disabled this previously).

Make sure you push the WPS button on the client device within 2 minutes after the WPS 

button on the router is pushed.

For more information on WPS, see 

30.

Login Problems

If you are unable to log in to the wireless router, check the following:

If you are using an Ethernet-connected computer, check the Ethernet connection 

between the computer and the router as described in the NETGEAR Wireless Router 
Setup Manual.

Make sure you are using the correct login information. The factory default login name is 

admin and the password is password. Make sure that the Caps Lock is off when 
entering this information.

Make sure your computer’s IP address is on the same subnet as the router. If your are 

using the recommended addressing scheme, your computer’s address should be in the 
range of 192.168.1.2 to 192.168.1.254. Refer to your computer’s documentation or see