Netgear JNR1010v2 사용자 설명서

The following describes tips for troubleshooting some common problems:



Unplug and turn off the cable or DSL broadband modem. 

Turn off the router and computers.

Plug in the cable or DSL broadband modem and turn it on. Wait two minutes.

Turn on the router and wait two minutes.

Turn on the computers.

Make sure that the Ethernet cables are securely plugged in: 

The Internet LED on the router is lit when the Ethernet cable connecting the router and 
the modem is plugged in securely and the modem and router are turned on. 

For each powered-on computer connected to the router by an Ethernet cable, the 
corresponding numbered router Ethernet port LED is lit. 

Make sure that the wireless settings in the computer and router match exactly. 

For a wirelessly connected computer, the wireless network name (SSID) and wireless 
security settings of the router and wireless computer must match exactly. 

If you set up an access list in the Advanced Wireless Settings screen, you must add each 
wireless computer’s MAC address to the router’s access list.

Make sure that the network settings of the computer are correct: 

Wired and wirelessly connected computers must have network IP addresses on the same 
network as the router. The simplest way to meet this requirement is to configure each 
computer to obtain an IP address automatically using DHCP.