Netgear JNR1010v2 사용자 설명서

If the error persists, you might have a hardware problem. Contact technical support at 

.

When the router is turned on, the LEDs light for about 10 seconds and then turn off. If all the 
LEDs stay lit, a fault exists within the router.

If all LEDs are still lit one minute after power-up, try the following:

Turn off the power and back on to see if the router recovers.

To return the router to its factory settings, press and hold the Restore Factory Settings 
button. 

If the error persists, you might have a hardware problem. Contact technical support at 

.

If one of the Ethernet port LEDs or the Internet LED does not light when the Ethernet 
connection is made, check the following:

Make sure that the Ethernet cable connections are secure at the router and at the modem 
or computer.

Make sure that power is turned on to the connected modem or computer.

Be sure that you are using the correct cable.

When you connect the router’s Internet port to a cable or DSL broadband modem, use 
the cable that was supplied with the cable or DSL broadband modem. This cable can be 
a standard straight-through Ethernet cable or an Ethernet crossover cable.

If the WiFi LED stays off, check to see if the WiFi On/Off button on the router has been 
pressed. This button turns the wireless radio in the router on and off. The WiFi LED is lit when 
the wireless radio is turned on.

If, after you use the Push 'N' Connect (WPS) function, the WPS LED blinks green rapidly, 
check the following:

Make sure that you have used the WPS button on the front of the router and not the 
WPS

 

Wizard on the Add WPS Client screen.

Check that PIN verification succeeded for the wireless device that you are adding to the 
wireless network.