Netgear FVS318v3 사용자 설명서
Reference Manual for the ProSafe VPN Firewall FVS318v3
3-6
Connecting the Firewall to the Internet
January 2005
3.
Click Done to finish. If you have trouble connecting to the Internet, see
to correct basic problems.
Figure 3-6: NETGEAR Smart Wizard Configuration Assistant success screen
Note: The Smart Wizard Configuration Assistant only appears when the firewall is in its factory
default state. After you configure the VPN firewall router, it will not appear again. You can always
connect to the firewall to change its settings. To do so, open a browser such as Internet Explorer
and go to http://www.routerlogin.net. Then, when prompted, enter admin as the user name and
password for the password both in lower case letters.
default state. After you configure the VPN firewall router, it will not appear again. You can always
connect to the firewall to change its settings. To do so, open a browser such as Internet Explorer
and go to http://www.routerlogin.net. Then, when prompted, enter admin as the user name and
password for the password both in lower case letters.
You are now connected to the Internet!
Troubleshooting Tips
Here are some tips for correcting simple problems you may have.
Be sure to restart your network in this sequence:
1.
Turn off the VPN firewall router, shut down the computer, and unplug and turn off the modem.
2.
Turn on the modem and wait two minutes
3.
Turn on the VPN firewall router and wait one minute
4.
Turn on the computer.