Fujitsu P2X0-0202-01EN 사용자 설명서
Chapter 6 Messages
49
P2X0-0202-01EN ETERNUSmgr User Guide -Introduction-
All Rights Reserved, Copyright © FUJITSU LIMITED 2007
6
Multiple statuses for a component are output joined by "&" symbols.
[Example]
The following message is output when all components of the target device are normal.
"No hardware error detected."
Depending on the Target Type or version of firmware used, actual format and contents of messages may
differ slightly from the above.
differ slightly from the above.
6.4
Log Messages
This section describes the messages output by ETERNUSmgr to the log files and how to respond to them.
ETERNUSmgr's log files are saved in text format.
ETERNUSmgr's log files are saved in text format.
■
Regular Messages (CODE 0XX)
stxpoll Service Started (CODE 001)
[Explanation] stxpoll service has started.
[Response]
[Response]
None
Get Status Success "server:port/status" (CODE 004)
[Explanation] Current status was successfully obtained from the target device.
[Response]
[Response]
None
Send Mail "name@server" (CODE 005)
[Explanation] An E-mail was sent.
[Response]
[Response]
None
Initialize "parameter" (CODE 006)
[Explanation] The values set at start-up are displayed.
[Response]
[Response]
None
Create File "file name" (CODE 007)
[Explanation] A file was created.
[Response]
[Response]
None
Erase File "file name" (CODE 008)
[Explanation] A file was deleted.
[Response]
[Response]
None
ControllerEnclosure#00:ALARM&BTU-WARNING
DriveEnclosure#00:ALARM
DriveEnclosure#10:WARNING
BatteryEnclosure#00:ALARM