Avaya CMC1 사용자 설명서

If you have a direct connection between the RFA and the switch, do the following:

1. Go to the RFA website, and, following the instructions in the “Deliver to G3r/G3si/G3csi” 

chapter of the RFA Job Aid, deliver the License File.

Note:

This procedure sends the License File to the switch and installs it. In order for this 
option to work, the INADS connection to the switch must be working.

2. If the system has IP endpoints registered and you unplugged the Ethernet cable from the 

TN799 (C-LAN) circuit pack, replug the cable.

This re-registers the IP endpoints.

If you do not have a direct connection between RFA and the switch, do the following:

1. Go to the RFA website, and, following the instructions in the “Deliver to G3r/G3si/G3csi” 

chapter of the RFA Job Aid, deliver the License File to your laptop/PC.

2. Open the License Installation Tool (LIT) application at your laptop/PC.

3. Use the LIT instructions to add a switch connection profile to the tool.

4. Use the LIT instructions to install the License File on the switch.

5. If the system has IP endpoints registered, and you unplugged the Ethernet cable from the 

TN799 (C-LAN) circuit pack, replug the cable.

This re-registers the IP endpoints.

To display the memory-configuration:

1. Log in as craft. If the 

Translation Corruption Detected

 message appears, refer to 

2. Type display memory-configuration and press Enter. Make sure that in the 

Total

 

DRAM

 

field the 

SIMM

 field in the 

SPE-A

 column says 16.