Sanyo PLC-WXE45 사용자 가이드

Connect the projector’s AC power cord into an AC

outlet. The POWER indicator turns red. Open the lens

cover.
Press the POWER ON/STAND-BY button on the

remote control. The POWER indicator becomes green

and the cooling fans start to operate. The preparation

display appears on the screen and the count down

starts.

The preparation display disappears after 30 seconds.

After the countdown, the input source that was

selected the last time and the Lamp mode status icon

(see page 46) will appear on the screen.

If the projector is locked with a PIN code, a PIN code

Input Dialog Box appears. Enter the PIN code as

instructed below.

See page 46 for the Lamp mode.

Video

Selected Input Source and Lamp Mode

Complete peripheral connections (with a computer,

VCR, etc.) before turning on the projector.

Lamp mode status

After the OK icon

disappears, you can

operate the projector.

PIN Code Input Dialo� Box

Turnin� On the Projector

Enter a PIN code

Select a number by pressing the Point

▲▼

buttons, and

then press the Point

►

button to fix the number and move

the pointer. The number changes to "". If you fixed an

incorrect number, move the pointer to the number you want

to correct by pressing the Point

◄

button, and then select

the correct number by pressing the Point

▲▼

buttons.

Repeat this step to complete entering a four-digit number.

"1234" is set as the initial PIN code at the factory.

After entering the four-digit number, move the pointer to

"Set" by pressing the Point

►

button. Press the SELECT

button so that you can start to operate the projector.

If you entered an incorrect PIN code, "PIN code" and the

number () turns red. Enter the correct PIN code all

over again.

What is PIN code?

PIN (Personal Identification Number) code is a security code

that allows the person who knows it to operate the projector.

Setting the PIN code prevents unauthorized use of the

projector.

A PIN code consists of a four-digit number. Refer to the PIN

code lock function in the Setting Menu on pages 47–48 for

locking operation of the projector with your PIN code.

Note:
• When the Input Search function is set on

On1 or On2, the input signal will be searched
automatically (p.44).

• When the Logo select function is "Off,” the

logo will not be displayed on the screen
(p.42).

• When the "Countdown off" or "Off" is selected

in the Display function, the countdown will not
be shown on the screen (p.41).

• During the countdown period, all operations

are invalid.

• If the PIN code number is not entered within

three minutes after the PIN code dialog box
appeared, the projector will be turned off
automatically.

• The “1234” is set as the initial PIN code at the

factory.

CAUTION ON HANDLING THE PIN CODE

If you forget your PIN code, the projector can no

longer be started. Take a special care in setting a

new PIN code; write down the number in a column

on page 70 of this manual and keep it on hand.

Should the PIN code be missing or forgotten, consult

your dealer or service center.

PIN code

Basic Operation

Note:
The Filter warning and Lamp replacement
icons may appear on the screen depending on
the usage state of the projector.