Netgear GS510TP-100NAS 사용자 설명서

Step 3: Checking the Installation

Before applying power to the switch, perform the following:

Inspect the equipment thoroughly.

Verify that all cables are installed correctly.

Check cable routing to make sure cables are not damaged or creating a safety hazard.

Ensure all equipment is mounted properly and securely.

Step 4: Connecting Devices to the Switch

The following procedure describes how to connect PCs to the switch’s RJ-45 ports. The 
GS510TP Smart Switch contains Auto Uplink technology, which allows the attaching of 
devices using either straight-through or crossover cables.

`

`

Connect each PC to an RJ-45 network port on the Switch front panel (

Category 5 (Cat5) Unshielded Twisted-Pair (UTP) cable terminated with an RJ-45 connector 
to make these connections.

Ethernet specifications limit the cable length 

between the switch and the attached device to 100 m 
(328 ft.).