Avaya P130 사용자 설명서

Chapter 6        Avaya P130 CLI

74

 Avaya P130 User’s Guide

Example:

To set port 2 on module 1 to full duplex:
P130-1# set port duplex 1/2 full
Port 1/2 set to full-duplex.
P130-1# 

Use the s

et port flowcontrol command to set the send/receive flow-control 

frames (whether proprietary or IEEE 802.3x) for a full duplex module port. Each 
direction can be configured separately.
This command is supported on Fast and Gigabit Ethernet switching ports.

The syntax for this command is:
set port flowcontrol {receive | send | all}<mod_num/
port_num>{off | on | prop}

receive

Indicates whether the port can receive administrative status 
from a remote device. Available only for Gigabit Ethernet 
modules with negotiation set to off.

send

Indicate whether the local port can send administrative status 
to a remote device. Available only for Gigabit Ethernet 
modules with negotiation set to off.

all

Send and receive (symmetric flow control).

mod_num

Module number 

port_num

Number of the port on the module 

off

Used with receive to turn off an attached device's ability to 
send flow-control packets to a local port. Used with send to 
turn off the local port's ability to send administrative status to a 
remote device.

on

Used with receive to require that a local port receive 
administrative status from a remote device. Used with send, 
the local port sends administrative status to a remote device.

prop

Proprietary flow control.