Metrologic Instruments IS1650 사용자 설명서

 

 

13

I

NSTALLATION

 

C

ABLE 

I

NSTALLATION 

(I

NTERFACE 

S

PECIFIC

) 

 

1.  Turn off the host device. 

 

2.  Plug the 10-pin RJ45 male end of the 

PowerLink cable into 10-pin socket on 
the IS1650.  There will be an audible 
click when the connector lock 
engages. 

 

3.  Disconnect the keyboard from the 

host device. 

 

4.  Connect the “Y” ends of the 

communication cable to the 
keyboard and keyboard port on the 
host device. 
If necessary, use the male/female 
adapter cable supplied with the 
scanner for proper connections. 

 

5.  Plug the external power supply 

(required) into the power jack on the 
PowerLink cable. 

 

Check the AC input requirements 
of the power supply to verify the 
voltage matches the AC outlet.  
The outlet must be located near 
the equipment and be easily 
accessible. 

6.  Connect the power supply transformer to an appropriate AC power outlet. 

 

7.  The IS1650 will start to initialize.  All LEDs (yellow, white, and blue) will light 

for approximately two seconds then start to alternately flash.  When the 
scanner has finished initializing the LEDs will stop flashing and the unit will 
beep three times indicating that the scanner is ready for use.  

 

8.  Turn on the host device. 

 

Plugging the scanner into a port on the host system does not guarantee 
that scanned information will be communicated properly to the host 
system.  The scanner is shipped from the factory configured with default 
settings.  Please refer to the MetroSelect Single-Line Configuration 
Guide (

MLPN 

00-02544) or MetroSet2’s help files for instructions on 

changing the scanner’s configuration.  In addition, please check that the 
scanner and host system are using the same communication protocol.  

 

See SELV Power caution statement located on page 10 of this manual.