Metrologic Instruments IS1650 사용자 설명서

 

 

15

I

NSTALLATION

 

C

ABLE 

I

NSTALLATION 

(I

NTERFACE 

S

PECIFIC

) 

 
1.  Turn off the host device.  
 
2.  Plug the male 10-pin RJ45 end of 

the MVC cable into the 10-pin 
socket on the IS1650.  There will be 
an audible click when the connector 
lock engages. 

 
3.  Connect the other end of the MVC 

cable to the host device. 

 
4.  Turn on the host device. 
 
5.  The IS1650 will start to initialize.   

All LEDs (yellow, white, and blue) 
will light for approximately  
two seconds then start to 
alternately flash.  When the scanner 
has finished initializing the LEDs 
will stop flashing and the unit will 
beep three times indicating that the 
scanner is ready for use.  

 
 
 
 
 
 
 
 
 

 
 

Plugging the scanner into a port on the host system does not guarantee 
that scanned information will be communicated properly to the host 
system.  The scanner is shipped from the factory configured with default 
settings.  Please refer to the MetroSelect Single-Line Configuration 
Guide (

MLPN 

00-02544) or MetroSet2’s help files for instructions on 

changing the scanner’s configuration.  In addition, please check that the 
scanner and host system are using the same communication protocol.  

 
 

See SELV Power caution statement located on page 10 of this manual.