Metrologic Instruments IS1650 사용자 설명서

 

 

14 

I

NSTALLATION

 

C

ABLE 

I

NSTALLATION 

(I

NTERFACE 

S

PECIFIC

)

 
1.  Turn off the host device.  

 

2.  Plug the male 10-pin RJ45 end of 

the PowerLink cable into the 10-pin 
socket on the IS1650.  There will be 
an audible click when the connector 
lock engages. 

 

3.  Plug the other end of the 

communication cable into the host’s 
keyboard port. 

 
4.  Plug the external power supply 

(required) into the power jack on the 
PowerLink cable. 

 

Check the AC input requirements 
of the power supply to verify  
the voltage matches the AC 
outlet.  The outlet must be located 
near the equipment and be easily 
accessible. 

5.  Connect the power supply 

transformer to an appropriate AC 
power outlet. 

 

6.  The IS1650 will start to initialize.  All LEDs (yellow, white, and blue) will light 

for approximately two seconds then start to alternately flash.  When the 
scanner has finished initializing the LEDs will stop flashing and the unit will 
beep  three times indicating that the scanner is ready for use. 

 

7.  Turn on the host device. 
 
 

Plugging the scanner into a port on the host device does not guarantee 
that scanned information will be communicated properly to the host 
device.  The scanner is shipped from the factory configured with default 
settings.  Please refer to the MetroSelect Single-Line Configuration 
Guide (

MLPN 

00-02544) or MetroSet2’s help files for instructions on 

changing the scanner’s configuration.  In addition, please check that the 
scanner and host system are using the same communication protocol.   

 
 

See SELV Power caution statement located on page 10 of this manual.