Uniden BC-RH96 사용자 설명서
9
Route the Remote Cable through the Slotted Guide
(3) so it lies flat. Route the Power Cord so it does
not interfere with any other wires.
not interfere with any other wires.
Using Hook and Loop Material
The rear of the unit, when all connectors and cables
are properly routed, is flat. This permits using hook
and loop material (not supplied) that has a heavy-duty
peel and stick adhesive on one side. This material is
generally available from electronic supply stores and
hardware stores.
Do not apply the tape to the rear until all cables are
installed and routed correctly.
Do not cover the slotted guide with the tape.
and loop material (not supplied) that has a heavy-duty
peel and stick adhesive on one side. This material is
generally available from electronic supply stores and
hardware stores.
Do not apply the tape to the rear until all cables are
installed and routed correctly.
Do not cover the slotted guide with the tape.
5.
Follow the directions supplied with the hook and loop
material. Locate a suitable spot on the dash, console,
or other area. If you use the Remote Head in another
place such as a radio room, using tape lets you quickly
mount or remove the Head as desired.
material. Locate a suitable spot on the dash, console,
or other area. If you use the Remote Head in another
place such as a radio room, using tape lets you quickly
mount or remove the Head as desired.
Note: The two slots on the front of the Remote Head
cannot be used for mounting. These slots are cosmetic
features only.
cannot be used for mounting. These slots are cosmetic
features only.