Festool PI567696 사용자 설명서

7

The standard STF 115 x 225 mm Stickfi x sanding 
pad can be exchanged for the 115 x 225 mm sand-
ing pad for use with clamping paper. Loosen the 
six fastening screws (5.1). 

Both sanding pads (with and without Stickfi x cov-
ering) are also available with an edge protector 
(KS) to protect the edge of the pad from premature 
damage. 

 Always use original Festool sanding 

materials!

Self-adhesive abrasives such as Stickfi x sanding 
disks and sheepskin polishers can be attached to 
the Stickfi x sanding pads. Simply press the abra-
sives onto the sanding pads and remove after use. 

Please note: Only use sanding pads with an 
undamaged Stickfi x coating. Before use, check 
whether the adhesive layer has been damaged 
due to improper use (e.g. melting) 

In addition to the Stickfi x abrasives, Festool also 
offers perforated abrasives for clamp-fitting. 
Unperforated sandpaper can be perforated with 
the Festool “Lochfi x” punching device. 

Start clamping the abrasive on the back of the 
tool by raising the clamping lever (6.1) and thus 
opening the clamping device. Insert abrasive up 
to limit stop and lower clamping lever into initial 
position. Place the abrasive on the sanding pad, 
pull taught and clamp on the front. 

5.1

6.1