Patton electronic 4110 사용자 설명서
1. Configure IP address
40
SmartNode 4520 & 4110 Series User Manual
4 • Getting started with the SmartNode
1. Configure IP address
Power connection and default configuration
First the SmartNode must be connected to the mains power supply with the power cable. Wait until the 'Run'
LED stops blinking and lights constantly. Now the SmartNode is ready.
LED stops blinking and lights constantly. Now the SmartNode is ready.
The factory default configuration for the Ethernet interface IP addresses and network masks are listed in
Both Ethernet interfaces are activated upon power-up.
If these addresses match with those of your network, go to section
on page 42. Otherwise, refer to the following sections to change the addresses and network masks.
Connect with the serial interface
The Console port is wired as an EIA-561, RS-232 port. Use the included Model 16F-561 adapter and cable (see
) between the SmartNode’s Console port and a PC or workstation’s RS-232 serial interface. Activate the
terminal emulation program on the PC or workstation that supports the serial interface (e.g. HyperTerm).
Figure 25. Connecting to the terminal
Terminal emulation program settings:
•
9600 bp
•
no parity
The Interconnecting cables shall be acceptable for external use
and shall be rated for the proper application with respect to volt-
age, current, anticipated temperature, flammability, and
mechanical serviceability.
and shall be rated for the proper application with respect to volt-
age, current, anticipated temperature, flammability, and
mechanical serviceability.
Table 8. Factory default IP address and network mask configuration
IP Address
Network Mask
Interface Ethernet 0 (ETH0)
DHCP
DHCP
Interface Ethernet 1 (ETH1)
192.168.1.1
255.255.255.0
CAUTION
Console
VoIP
Gateway Router
ToIP
Integrated
Access Device
SmartNode 4524
Link
100M
Activity
0/0
0/1
0/2
0/3
En
et 0
Vo
ice
Po
rts
Power
Run
V
oIP
Link
Link
100M
Activity
En
et
1