Patton electronic 4110 사용자 설명서

Bootloader

SmartNode 4520 & 4110 Series User Manual 

The following procedure downloads the application image (SmartWare) for the mainboard. See the note below 
on how to download the respective CLI description file.

Copies the SmartWare application image from the 
persistent memory (flash:) to the volatile memory 
(RAM) from where it will be executed.

Starts the SmartWare application telling it to use 
‘factory-config’ as startup configuration. 
You can also start-up with any other configuration 
available in the persistent memory (nvram:) by pro-
viding its name instead of ‘factory-config’.

RedBoot> ip_address - l 
local_ip_address [/mask_len]

Sets the IP address and subnet mask of the 
Ethernet interface 0/0 which shall be used to 
receive the new application image.
mask_len is the length of the network address 
(or the number of  1’s within the subnet mask).
See Note below.

RedBoot> ip_address -g gateway

Sets the IP address of the default gateway.

RedBoot> ping -h tftp-server_ip_address

Tests the connectivity to the TFTP server.

RedBoot> load -r -v -h host -b 
base_address file_name

Downloads an application image into the vola-
tile memory (RAM) from where the SmartNode 
could directly execute it.
host: IP address of the TFTP server
base_address: memory location where to store 
the application image. Use the default address 
0x1800100
file_name: path and name of the file on the 
TFTP server. Note: use the image file that con-
tains the whole application, not the image 
parts.

RedBoot> fis delete -n 1

Deletes the first application image.
Reply with ‘y’ to the confirmation request.

RedBoot> fis create

Stores the downloaded application image to 
the permanent memory (flash:).
Reply with ‘y’ to the confirmation request.

RedBoot> fis list -l

Checks whether the image has been success-
fully stored, whether it is the desired Release 
and Build, and whether it is valid.