Wilton FK350-4 사용자 설명서
10
Controls
Control Panel – FK350
The Control Panel (Figure 4) is located on the
front the cabinet stand and consists of the
Power and High/Stop/Low switches, described
below.
front the cabinet stand and consists of the
Power and High/Stop/Low switches, described
below.
Power Switch – The Power switch has two
positions, Off and On.
positions, Off and On.
High/Stop/Low Switch – This switch controls
the blade speed. To operate the saw, the power
switch must set to on, High or Low must be
selected and the Run Trigger depressed.
the blade speed. To operate the saw, the power
switch must set to on, High or Low must be
selected and the Run Trigger depressed.
Figure 4
Trigger Handle – FK350
To operate, the Power switch must be set to on
a Hi or Low speed selection made, and the
trigger handle, depressed.
a Hi or Low speed selection made, and the
trigger handle, depressed.
Figure 5
Control Panel – FK350-SX
Emergency – Emergency Stop: This turns off
the controls, and the machine. When used, it
requires that “Control On” button be pushed.
the controls, and the machine. When used, it
requires that “Control On” button be pushed.
Vise – Open/Close (Manual mode
Mode selection – Select Semi-auto, or Manual
mode.
mode.
Start – In manual mode, this starts the saw
blade. In Semi-auto, this starts the cut-cycle.
blade. In Semi-auto, this starts the cut-cycle.
Head-UP/ Head-Down – Manual mode only
Feed rate – sets feed rate of cut cycle
Figure 6
High/Stop/Low Switch – Refer to Figure 7;
located on the front of the cabinet stand;
controls the blade speed (Figure 7).
located on the front of the cabinet stand;
controls the blade speed (Figure 7).
Figure 7