Wilton FK350-4 사용자 설명서

11

Before using the machine: 

‰

Check that safety devises (ex., blade 
guards) are in position and work perfectly 
and that personal safety requirements are 
complied with.  

‰

Check the sharpness of the blade and verify 
coolant flow. 

1.  Make sure the work piece is securely 

clamped in the vise. 

2.  Turn the power on (A, Fig. 8). 

3.  Select the cutting speed (B, Fig. 8). 

4.  Grip the trigger handle (Figure 5) on the 

control lever.  

5.  Start the blade by pressing the micro-switch 

on the handgrip. 

The down stroke speed of the head is controlled 
manually by the operator. The coolant pump is 
activated during the time that the head is below 
the upper limit position. 

When the cut is complete: 

6.  Raise the head. 

7.  Remove the work piece from the vise using 

the vise hand wheels. 

To operate machine,  

1. Clear 

the 

Emergency Stop. 

2. Press 

Control On.

3.  Select the desired blade speed. 

4. Select 

Manual or Semi-auto.

Manual Mode – Position material and tighten 
the vise. Position the head switch to Head-Down 
until cut is complete. Position the head switch to 
Head-Up until head retracts to desired height. 

Semi-auto Mode – Set the head travel trips to 
achieve desired head travel extents. Position 
material in the vise allowing approximately .125" 
for proper air vise operation, and then press 
cycle start. After the cycle is complete, the vise 
opens for material repositioning. 

Note: The coolant pump is activated while the 
motor is running.