Maytag W10274252A 사용자 설명서

Gather the required tools and parts before starting installation. 
Read and follow the instructions provided with any tools listed 
here.

■

1" (2.54 cm) mounting screws (4)

■

A UL listed or CSA approved conduit connector

■

UL listed wire connectors

Check local codes. Check existing electrical supply. See 
“Electrical Requirements.”

It is recommended that all electrical connections be made by a 
licensed, qualified electrical installer.

IMPORTANT: Observe all governing codes and ordinances. 
When installing cooktop, use minimum dimensions given.

■

To eliminate the risk of burns or fire by reaching over the 
heated surface units, cabinet storage space located above 
the surface units should be avoided. If cabinet storage is to 
be provided, the risk can be reduced by installing a range 
hood that projects horizontally a minimum of 5" (12.7 cm) 
beyond the bottom of the cabinets.

■

The cooktop must be a specified cooktop that is approved to 
be installed either alone or over an undercounter built-in 
oven. Check the cooktop base approved installation label for 
your cooktop model number and approved combinations of 
cooktops and ovens that can be installed. If you do not find 
this label, your cooktop may not be approved for use over an 
undercounter built-in oven. Contact your dealer to confirm 
that your cooktop is approved.

■

Ovens approved for this type of installation will have an 
approval label located on the top of the oven. If you do not 
find this label, contact your dealer to confirm that your oven is 
approved. Refer to oven manufacturer’s Installation 
Instructions for approval for built-in undercounter use and 
proper cutout dimensions.

■

When installing cooktop over an undercounter built-in oven, 
do not fasten cooktop to countertop with screws. This will 
make the cooktop easier to remove if future servicing 
becomes necessary.

■

Use the countertop opening dimensions that are given with 
these Installation Instructions. Given dimensions are 
minimum clearances and provide 0" (0 cm) clearance.

■

Grounded electrical supply is required. See “Electrical 
Requirements” section.

IMPORTANT: To avoid damage to your cabinets, check with your 
builder or cabinet supplier to make sure that the materials used 
will not discolor, delaminate or sustain other damage.

All safety messages will tell you what the potential hazard is, tell you how to reduce the chance of injury, and tell you what can
happen if the instructions are not followed.

We have provided many important safety messages in this manual and on your appliance. Always read and obey all safety 
messages.

This is the safety alert symbol.

This symbol alerts you to potential hazards that can kill or hurt you and others.

All safety messages will follow the safety alert symbol and either the word “DANGER” or “WARNING.”

These words mean:

■

Tape measure

■

Phillips head screwdriver

■

Marker or pencil

■

Pliers