Maytag W10274252A 사용자 설명서

■

A 4-wire or 3-wire, single phase, 240 volt, 60 Hz., AC only 
electrical supply is required on a separate, 40-amp circuit, 
fused on both sides of the line. The model/serial number 
rating plate is located on the metal cabinet underneath the 
cooktop. See the following illustration.

■

Cooktops with 3-wire cable coming from the cooktop are 
rated 240 volt and do not have a neutral (white) wire. 

■

The cooktop should be connected directly to the junction box 
through flexible, armored or nonmetallic sheathed, copper 
cable. The flexible, armored cable extending from the fuse 
box or circuit breaker box should be connected directly to the 
junction box.

■

Locate the junction box to allow as much slack as possible 
between the junction box and the cooktop so that the 
cooktop can be moved if servicing becomes necessary in the 
future.

■

Do not cut the conduit. The length of conduit provided is for 
serviceability of the cooktop.

■

A UL listed or CSA approved conduit connector must be 
provided at each end of the power supply cable (at the 
cooktop and at the junction box). A listed conduit connector 
is already provided at the cooktop.

■

If the house has aluminum wiring follow the procedure below:

1. Connect a section of solid copper wire to the pigtail 

leads.

2. Connect the aluminum wiring to the added section of 

copper wire using special connectors and/or tools 
designed and UL listed for joining copper to aluminum.

Follow the electrical connector manufacturer's recommended 
procedure. Aluminum/copper connection must conform with 
local codes and industry accepted wiring practices.

1. Remove the shipping materials and tape from the cooktop. 

Remove the hardware package from inside the bag 
containing literature.

2. Using 2 or more people, gently place the cooktop into the 

cutout.  

IMPORTANT: Check that the front edge of the cooktop is 
parallel to the front edge of the countertop. If repositioning is 
needed, lift entire cooktop up from cutout to avoid scratching 
the countertop.

1. Remove the coil elements and burner bowls. 

■

Push in the edge of coil element toward the receptacle. 
Then lift it enough to clear the burner bowl.

■

Pull the coil element straight away from the receptacle.

■

Lift out the burner bowl.

2. Remove the 4 screws from inside each element opening and 

lift cooktop from cooktop base.

3. Using 2 or more people, gently place the cooktop in cutout 

and determine final location.

NOTE: Make sure that the front edge of the cooktop is 
parallel to the front edge of the countertop. If repositioning is 
needed, lift entire cooktop up from cutout to avoid scratching 
the countertop.

A