Avaya 555-231-743 사용자 설명서
GuestWorks and DEFINITY ECS Release 9
Technician Handbook for Hospitality Installations
Technician Handbook for Hospitality Installations
555-231-743
Issue 1
November 2000
Translations and Testing
220
Switch-to-PMS Link Translations
PMS Testing and Status
Use the test pms command to test the PMS link. If the link is not active, this
command sometimes causes the link to be established. The PMS test (Test 215)
must pass before you proceed with further testing.
command sometimes causes the link to be established. The PMS test (Test 215)
must pass before you proceed with further testing.
Use the status pms-link command to display the current status of the PMS link.
The following is an example of that screen:
The following is an example of that screen:
The fields are defined as follows:
■
Physical Link State
— If the link state is
Up
, the transmit/receive
lamps will be flashing, and all lamps except for the ringing indicator lamp
will be lit. This indicates that the link is active, and the call has been placed
from the netcon to the data module.
will be lit. This indicates that the link is active, and the call has been placed
from the netcon to the data module.
■
Protocol State
— If the protocol state is
Up
, the data module carrier
detect lamp is lit, and at least one status inquiry message has been
received and understood from the PMS. The data module transmit/receive
lamps will be flashing if the switch is talking with the PMS. If the lamps stay
on longer than the link idle timeout setting (usually 20 seconds), the switch
and the PMS are communicating. If the TD lamp flashes every 15 to 20
seconds, this indicates that the PMS is sending data to the switch.
received and understood from the PMS. The data module transmit/receive
lamps will be flashing if the switch is talking with the PMS. If the lamps stay
on longer than the link idle timeout setting (usually 20 seconds), the switch
and the PMS are communicating. If the TD lamp flashes every 15 to 20
seconds, this indicates that the PMS is sending data to the switch.
■
Number of Retries
— This count increments every 5 minutes for the
first 12 retries, and then every 15 minutes until the link is established. A
high number of retries could indicate that the netcon data channel is not
available because too many resources are assigned, or the data module
could be busy. If there are no retries to report, this field is not displayed.
high number of retries could indicate that the netcon data channel is not
available because too many resources are assigned, or the data module
could be busy. If there are no retries to report, this field is not displayed.
■
Maintenance Busy?
— This field shows whether the link is currently
maintenance busied-out. If the link is not maintenance busied-out, this field
is not displayed.
is not displayed.
■
Database Swapping?
— If the field displays
yes
, the room images are
being transmitted between the switch and the PMS. If the field displays
pending
, the database swap has been requested by the switch. If the field
displays
no
, the PMS link is up.
status pms-link
PMS LINK STATUS
Physical Link State: Down
Protocol State: Down
Maintenance Busy? No
Database Swapping? No