Maytag RCS10DA 사용자 설명서

To avoid the risk of electrical shock, personal injury, or death,
disconnect power to oven and discharge the capacitors before
following any disassembly procedure.

©2004 Maytag Services

16023293   Rev. 0

29

4. Replace diode and reverse procedure to reassemble.

1. Disconnect power to oven and remove outer case,

(see "Outer Case" procedure).

2. Discharge high voltage capacitor, (see "High Voltage

Capacitor" section).

3. Disconnect and label wire leads from transformer.
4. Remove screws securing transformer and remove.
5. Replace transformer and reverse procedure to

reassemble.

1. Disconnect power to oven and remove outer case,

(see "Outer Case" section).

2. Disconnect and label wires.
3. Remove fuses to gain access to screws securing

assembly.

4. Carefully lift tab to release assembly from locating

pin.

5. Replace component(s) and reverse procedure to

reassemble.

Before replacing a blown monitor fuse, test the primary
interlock switch, secondary interlock switch, monitor
switch, and power relay contacts for proper operation.
If the monitor fuse is blown by a failed switch
operation, all switches and controller must be

replaced.

Magnetron is located on the side of the cavity.

1. Disconnect power to oven and remove outer case,

(see "Outer Case" section).

2. Discharge high voltage capacitor, (see "High Voltage

Capacitor" section).

3. Remove terminal plug from filament terminals.
4. Remove screws securing magnetron cutout bracket to

magnetron.

5. Remove screws securing magnetron to the wave

guide.

6. Replace magnetron and reverse procedure to

reassemble.

NOTE: When replacing magnetron, make sure gasket is

in correct position and in good condition.

During replacement of magnetron, be certain the R.F.
anode gasket is in place around the anode stud.

A microwave leakage test must be performed anytime
a magnetron assembly is removed, replaced,
disassembled, or adjusted for any reason.