Maytag RCS10DA 사용자 설명서

To avoid the risk of electrical shock, personal injury, or death,
disconnect power to oven and discharge the capacitors before
following any disassembly procedure.

30

16023293   Rev. 0

©2004 Maytag Services

1. Disconnect power to oven and remove outer case,

(see "Outer Case" procedure).

2. Remove outer case.
3. Disconnect wiring from blower motor.
4. Remove screws securing scroll to chassis.
5. Slide scroll discharge snout from partition and lift

scroll assembly from unit.

6. Replace component and reverse procedure to

reassemble.

  

NOTE: Be careful not to bend antenna when removing

splatter shield. Shield snaps into a lip in front of
the oven and three slots in the back.

1. Place your thumbs in the two indentations in front of

the shield.

2. Press lightly towards the back and carefully lower

shield away from antenna.

3. Pull shield out of the back slots and out of the oven.

1. Remove splatter shield from oven cavity.
2. Remove two mounting rivets on the top of oven cavity

to remove cradle. Support cradle before removing
mounting rivets to avoid damage to antenna
assembly.

1. Disconnect power to oven and remove outer case,

(see "Outer Case" procedure).

2. Remove outer case.
3. Disconnect wire terminal s from stirrer motor.
4. Remove screws securing stirrer motor to wave guide.
5. Replace component and and reverse procedure to

reassemble.

NOTE: When replacing stirrer motor, verify motor shaft is

aligned with antenna shaft before securing with
screws.