Black Box DVI 사용자 설명서

 

 

9

3. Operation 

The AC2000A-S allows multiple control methods, such as front-panel 
buttons, RS232 serial commands, or GUI software.  

The EDID ROUTING button is used to select what EDID information will 
be sent to the video source when requested.  The choices are: 

DVI-LOCAL 

Device connected to the AC2000A-S 
OUTPUT DVI Connector 

UTP-REMOTE 

Device connected to the AC2000A-R 
OUTPUT DVI Connector

EMULATE DEFAULT 

FACTORY EDID Information stored in 
AC2000A-S Unit

EMULATE LEARNED 

EDID Information stored by USER from Display 
Device either connected locally or remotely and unit 
put in LEARN mode 

The LEARN button is used to program EDID information from either the 
sender’s local OUTPUT DVI connector or the receiver’s Remote OUTPUT 
DVI Connector into the “EMULATE LEARNED” memory and save it for 
future use. 

Use the EDID ROUTING button and select which device you desire to 
LEARN; either the DVI-LOCAL or UTP-REMOTE. 

Press the LEARN button for 3 seconds; the EMULATE LEARNED LED 
will begin to flash to indicate that LEARN mode is in progress. 

When the unit has successfully completed LEARNING the EDID of the 
selected device; the AC2000A-S unit will sound 2 short beep tones. A long 
tone is sounded to indicate an error occurred.  

Programming the EMULATE DEFAULT position can only be done 
through serial commands or the GUI software. 

The Output Boost buttons are used to enable or disable the DVI output 
signal boost.